Skip to content
All case studies

Real job 5 November 2026 · Mercedes E-Class diesel

ABS light on. Scan, clear and re-check in half an hour.

An E-Class with the ABS and ESP light on. A scan of the whole car, a clear the garage asked for, and a second read showed which fault was real and which messages only followed from it.

Fault codes

  • C04AB00Left front wheel speed sensor, signal implausiblecurrently present
  • C04A600Left front wheel speed sensor, mechanical faultstored
  • C04B000Left front wheel speed sensor, signal faultypresent again after the clear
  • 37control units answered the whole-car scan
  • 5other units logging messages that only followed from one wheel speed signal
  • 30 minfrom the start of the scan to the end of the check after the clear
  1. The fault.

    A Mercedes E-Class diesel with the ABS and ESP warning light on.

  2. Scan the whole car.

    The garage plugged in a Gateway PRO. Every control unit that answered was identified and its fault memory read, 37 units in all. Read-only: nothing was cleared, coded or activated during the scan.

  3. One cause, many messages.

    The ESP control unit reported the left front wheel speed sensor: signal implausible, currently present, with a stored mechanical fault on the same sensor. The transmission, the shift module, the power steering, the collision assist and the rear camera all logged messages that follow from that one missing wheel speed.

  4. The clear, on request.

    The garage asked for the ESP fault memory to be cleared to see what came back. Only that one unit was cleared. Every other unit was left as it was.

  5. It came straight back.

    After the next ignition cycle, without a road test, the fault was there again as "signal faulty". A fault the ESP finds at switch-on points to the electrical side of the circuit: sensor, connector or wiring. It points away from the encoder ring.

  6. Two reports.

    The garage got the full scan report and the check after the clear, with the sensor checks in order. The other active faults in the car, not related to the light, were listed separately.

Who did what.

  1. The specialist, JohnMore than twenty years in automotive electronics. Ran the session, separated the cause from the messages that followed it, and read the result of the clear.
  2. DEXRead every control unit that answered, grouped the faults and put both reports together.
  3. The garageAsked for the clear, cycled the ignition, and received the checks for the sensor circuit.

The reports, all 5 pages.

Full vehicle scan (PDF)

  1. Full vehicle scan, page 1
  2. Full vehicle scan, page 2
  3. Full vehicle scan, page 3

Check after the clear (PDF)

  1. Check after the clear, page 1
  2. Check after the clear, page 2

Vehicle identity and the garage's name removed. The report is shown as it was written on the day, as engineering judgement from the values read. We have not been told how the repair ended, so this page does not claim it. This is one job. Every fault is different.

Share this job