Skip to content
For garages

Your first specialist session.

From the booking to the report in your hand: what you do, what the specialist does, and what the light on the Gateway is telling you.

6 steps. About 2 minutes to read. Updated .

  1. Step 1: Book the session

    Fill in the booking page with the car and the fault: what it does, and what has already been replaced or tried. WhatsApp opens with everything you typed. Press send.

    We confirm the time and the price for your job before any work starts. Nothing is charged on the page.

    Booking request: specialist sessionExample

    From: Example Garage

    Device: Gateway PRO Wi-Fi

    Car: Mercedes Vito 2017, AB12 CDE

    Job: Diagnosis

    When: Tomorrow morning

    Fault: ABS and ESP lights on since a front wheel bearing was replaced. Left front speed sensor already changed.

    The car will be ready as set out on the Before your specialist session page: yes

    The message the booking page writes for you. You only press send.
  2. Step 2: Get the car ready

    Before the time you were given: the car on a battery charger, everything electrical you do not need switched off, nothing else in the diagnostic socket, and somebody beside the car who can work the ignition and answer the phone.

    The session does not start below 12.4 V. The full list is short.

  3. Step 3: Plug in the Gateway

    Gateway PRO goes into the diagnostic port under the dash. The light blinks green while it connects. There is nothing to install and nothing to learn.

    If the light is still blinking after a couple of minutes, message us on WhatsApp and we will get it connected with you.

    • Blinking green Connecting.
    • Steady green Your specialist is on the car.
    The light on the Gateway tells you where the session is.
  4. Step 4: Steady green: the specialist is on the car

    When the light holds green, the specialist is working on the car from their own bench: reading every control unit, the stored faults and the live data as it happens.

    Stay beside the car. They will ask for the things only you can do: ignition on, engine running, a pedal pressed, a switch worked. Nothing is cleared, coded or programmed without your go-ahead.

  5. Step 5: Leave it in until you are told

    Do not unplug the Gateway or switch the ignition off until the specialist says the session is finished. A session is up to 45 minutes on the car.

    If something changes during the session, for example the charger drops out, the specialist stops at the first safe point and tells you.

  6. Step 6: Get the report

    You get the findings in plain English, and a written job report follows by email: what was found, what was done and what to check next. It is written so you can hand it to your customer. How to read your session report.

Good to know

  • A specialist session is £69 for up to 45 minutes. An urgent, same-day session is £109. These are launch prices, until 31 January 2027. From 1 February 2027 a session is £99 and an urgent session is £129.
  • If the car is not ready, the session does not start. We rebook you free of charge and the session is not counted.
  • Does the fault only show on the road? Say so when you book. You drive, and the specialist follows what the car does at the moment the fault appears.

Book a specialist session