Skip to content
For garages

Read your session report.

A written report follows every specialist session. This is what each part of it tells you, and how to use it with your customer.

About 2 minutes to read. Updated .

The header: which car, when, and what was done

The top of the report names the vehicle, the date and time, where the car was and the complaint. The last line says exactly what the specialist did, and what they did not do. If no coding or programming was done, the report says so.

First page of a remote diagnosis report: a header table, a summary box with the cause, and a numbered list of recommended checksOpen the page full size
A page from a real report, November 2026: header, summary and recommended checks. Customer and vehicle identity removed. Tap the page to open it full size.

The result: the answer first

The box under the header is the finding in a few sentences: the cause of the complaint and the evidence for it. If you only read one part, read this one.

Recommended checks: your job list

A numbered list, in the order to do them. Each one is a test you can do at the car with a meter or your eyes: supply and ground, wiring, connectors. The list tells you which result points to which part, so you can prove the cause before you order anything.

Active and stored faults

Every fault is marked active or stored. Active means it is present now. Stored means it happened earlier and is not present now.

Deal with active faults first. A stored fault that stays away after a clear is history, not a job.

A post-clear check report: a result box, and a sequence table with times, steps and faults marked active, stored or no faultsOpen the page full size
A page from a real report, November 2026: the result, then the sequence with active and stored faults. Customer and vehicle identity removed. Tap the page to open it full size.

The sequence: what happened, in order

When faults were cleared or a test was run, the report lists each step with its time and what came back. A fault that returns straight after a clear is a live fault, not an old one. In the report above it came back at the next switch-on, which pointed at the electrical side of one sensor circuit.

Health checks: worth watching, and in range

Some reports are a check rather than a fault hunt, for example a battery report on a hybrid. They sort every reading into two lists: worth watching and in range. Nothing is changed or cleared on the car for a report like this, and the report says so in its first line.

A battery report: a list headed worth watching, a list headed in range, and tables of readingsOpen the page full size
A page from a real battery report, November 2026. Customer and vehicle identity removed. Tap the page to open it full size.

Battery voltage

The battery voltage at the start and at the end of the session is shown on your job report. Low voltage sets faults in control units that have nothing wrong with them, so look at it before you blame a part.

What to give your customer

The report is written in plain English so you can hand it over as it is. With a Workshop Plan your garage leads every report, with AI Mechanic named as second provider.

Good to know

  • The pages shown here are from real remote-session reports, November 2026. Customer and vehicle identity removed.
  • A question about your report? Reply to the email it came in, or message us.

Book a specialist session